FS Built Ford Small Block 302
 

Here's a list of everything done, all parts are brand new, the motor has yet to be fired and is sitting at work in the shop.

Moroso 7L deep sump oilpan
Moroso pickup and oil pump and drive
Holley Mechanical Fuel Pump
Balanced, blueprinted crankshaft flywheel to harmonic
Pioneer flywheel
Mahle coated/forged flattop pistons
Block Bored .050 over
New waterpump
Comp Cams 284 cam
Comp Cams roller lifters, pushrods, and roller rockers
Mallory Performance Distributor and coil
Full(springs/valves) Edelbrock performer Aluminum heads 2.02/1.90
Edelbrock Performer RPM Airgap intake manifold
Edelbrock Elite series Tall Valvecovers
Holley 750cfm DP carb
BBK shorty equal length headers
Magnaflow 2.5" Stainless offroad X-pipe for foxbody stang
Ford Factory Reman'd T5 from '92 stang, all new gears/syncros
Centerforce 2 DF clutch
Brand new FORD motormounts for foxbody stang.
Aftermarket clutch cable and bracket(the only used part) and gripp bracket... changes adjuster to tranny instead of self adjuster under dash.

I think I'm missing things. Comes with a Foxbody shell if you'd like, was a 4cyl, the motor is sitting in it now.

I have most of the reciepts.

$11,000 invested. Asking $6500obo. I can send you pics if you'd like.

Ttt

Why? I was curious as to what this car was going to run, glws

I don't wanna got his route with the convertible, and the 4cyl is too much work to make it half decent so i wanna pass it one to someone that has the time for it.

bump

Offers?? It's sitting in our shop and I have a debtload to take care of

i dont think it will fit into my cherokee, sorry

I can make it hah

ttt

TTT.

Someone must know a ford guy.

upp