FS: J's Racing 4-2-1 header + T1R cat
 

9/10 condition J's Racing 4-2-1 header for both B16 and B18.

"Little" flat spot on the bottom, nothing will restricts air flow and NO ONE will be able to see it except ur damn self!! (I hate ppl who ask this question, sooner or later I bet u will flat it anyway......... )

Will fit your B16 for sure since my motor is B16

Will fit B18/B18R since its design for Integra Type R

2.5" collector

J's Racing donut ring is included

T1R cat ready with this bad boy, 7/10 condition, a bit scratch up on the bottom, but wont restricts air flow

Still have the J's Racing header gasket and will even throw in a O2 sensor

For those of u who is interested that is running B16, I will also included a custom bracket for this header since its designed for B18C5.


$600 FIRM (with all these extra goodies, dont waste ur time to lowball me)
$550 FIRM for just the header


http://www.jsracing.co.nz/images/J's...%20exhaust.jpg

any dents on the bottom, haha just kidding--bump

:ratedb:

:)

JDM ur B16 or B18 before summer peeps!!

jdm length or usdm?

thanks

JDM length. With proper cat u wont have any problem to install it!

All the way to the top, get this piece for DTP peeps!!

so i you use the t1r test pipe, you could run the stock usdm exuast?

yes, but why would u want to do that?

just wanted to know if it fits usdm legth exaust

All the way to the top~

considering selling just the test pipe?

thanks

$50 its yours if u still looking for it!

ttt top top top

Always open for REASONABLE offer!!

ttt

ttt

^I am interested in the cat, just wondering would the cat fit if I have the JDM ITR header?

you have a pic of the flat spot or any pics of the header? looking to by it!

is it a cat covertor? or just a test resonated test pipe?

Test pipe!

k, nvm then, =)

gl on sell

ttt

you have pm!