REVscene Automotive Forum - FS: Turbo Civic Part out.

REVscene Automotive Forum (https://www.revscene.net/forums/)

- USED Automotive Performance Parts ONLY (https://www.revscene.net/forums/used-automotive-performance-parts-only_23/)

- - FS: Turbo Civic Part out. (https://www.revscene.net/forums/555255-fs-turbo-civic-part-out.html)

FS: Turbo Civic Part out.

Garage Sale: Get this stuff gone.

Engine:

http://i7.photobucket.com/albums/y26...h/IMG_0480.jpg

LS-Vtec engine. This block has about 3,000kms on the rebuild if that. I may be going a tad on the high side, but better to be safe.

Its comprised of:

81mm JE Forged Pistons
81mm Mahle Moly Ring Set
Scat 4340 H-beam Rods with ARP hardware
ARP Head Studs
OEM B16 oil pump (might be ITR, but definately B16 if not, cant remember)
ACL Race Main and Rod Bearings
new Seals and Gaskets (rear main, front crank, cams seal, oil pan)

Ill part the block and sell it as a short block for $2000 obo

Head:

head has roughly 40,000kms on it. Stock head except for GSR Cams, AEM Cam Gears. Can sell the head as follows:

Head with stock b16 cams, stock cam gears, stock intake: 500
Head with GSR Cams, AEM Gears, JG Large plenum intake, Skunk2 70mm throttle bode: 1100
add another 150 if you want the dizzy

[b]take the motor/trans/intake/tb/dizzy etc for 3000obo! [b/]

Clutch and trans:

LS cable trans with OBX LSD. At the time of the LSD install, i had new diff and input shaft bearings and seals installed. Its as rebuilt as it can be. Shifts like butter, absolutely no grinds. $1000

ACT HDR6 Extreme Pressure plate with 6 puck unsprung hub. This clutch bites HARD. never had it slip on me or steve when he was at the strip. Lots of meat on it. $550. Can include flywheel. Cant remember if i lightened it or not.

turbo kit:

Custom tubular manifold b-series
Holset Hy35 9cm housing
Trust 50mm wastegate
2.5" charge pipes
large front mount intercooler
your choice of injectors (650, 880, 1000)
3" down pipe
waste gate dump pipe

Think thats all of it for the turbo kit. if im missing something, let me know and i can include it. Turbo still puts out a lot of volume. shaft play is starting to get noticable. if its too much for you, i can include a rebuild kit or replace the turbo.

$2500obo

Electronics:

AEM True boost - $250
AEM wideband - $200
Apexi AVCR - $400
Auto Meter Water temp gauge - $60 (phantom series)

Fuel System:

Aeromotive A1000 600L/hr fuel pump
Aeromotive A1000-6 High Volume Fuel Pressure regulator
Aeromotive inline -10 fuel filter with 100micron element
Russel -10 feed lines
Russel -8 Return Lines
AEM High flow Fuel Rail
Sumped Honda fuel tank with -10 feed and drain ports
Misc -6,-8,-10 AN fittings, adapters and unions

$900

Sub box and amp rack assembly. Also acts as a rear seat delete. makes it look like a crx in the back of a civic. you could run the sub box solely and not use the amp rack to retain your rear seats, but both pieces compliment each other

$400obo

Any pics of the AEM wideband? which model is it?

So is the head a P72 or PR3?

what did you run with this setup?

Quote:

Originally Posted by daval (Post 6208678)

Any pics of the AEM wideband? which model is it?

http://i7.photobucket.com/albums/y26...h/IMG_0478.jpg

http://i7.photobucket.com/albums/y26...h/IMG_0479.jpg

http://i7.photobucket.com/albums/y26...h/DSC00091.jpg

Glare from the flash made the faces looked like they were scratched. they are in mint shape. think i have a pic of them installed somewhere. will post that up as well

Quote:

Originally Posted by DB2-R81 (Post 6208912)

So is the head a P72 or PR3?

Head is a PR3-2 B16a

Quote:

Originally Posted by diddy4 (Post 6208933)

what did you run with this setup?

at 12psi it put down 278whp and it ran 12.1 @ 113mph. That was a personal best for me. Never got back to mission to make a run on high boost

If you are interested in selling the head send me some contact info and where we can meet up so I can have a look at it.
m_sasso@shaw.ca

part with turbo and wastegate?

Quote:

Originally Posted by "DA"token Black (Post 6209507)

http://i7.photobucket.com/albums/y26...SC8723_web.jpg
Are you selling these rims?

wheels are gone. thx for the interest. :)

Quote:

Originally Posted by tkils (Post 6209525)

part with turbo and wastegate?

yup ill part the turbo and gate.

what would your price be for Everything??
Because im thinking of putting it in my 90 civic hatch..Does it come with mounts and everything to do the swap??
or did you sell some of that already??

Quote:

Originally Posted by 90Civicefhatch (Post 6211568)

what would your price be for Everything??
Because im thinking of putting it in my 90 civic hatch..Does it come with mounts and everything to do the swap??
or did you sell some of that already??

mounts
linkage
axles
chipped ecu

are all gone.

gauges, motor/lsd trans, turbo, wastegate, wastegate dump pipe, downpipe, 3" exhaust i still have.

PM'ed

how much for the JG intake manifold and will it work with my b16a2?

Quote:

Originally Posted by GreddySiR (Post 6212231)

how much for the JG intake manifold and will it work with my b16a2?

PM'ed.

part with the front mount?and how much?and what size is it?