Installed hid kit, no more fog lights :( Why don't my fogs turn on when i press the button now? :( |
EDIT: they work but high/low beams are reversed... |
I'm guessing you got the HIDs from HID Outlet? |
Did they say it was just plug and play? |
Lol, nah i got them off craigslist... Yeah i tried switching all the wires back and forth and nothing... Oh well its not so annoying :( |
Well, clearly if it worked before and now it doesnt, it is a wiring issue with the HID's. Out of all of them ive seen, its always an issue with the wires swapped. I cant remember if the Z31 used sealed beams or 9004. But if it used 9004 bulbs, the center pin IIRC is the high beam, the left being low beam and right being ground. 99% of the time, its the high/low mixed up. Just get a test light, turn your high beams on, touch the terminals with the test light, if it lights up on the middle pin, then that is the high beam, now put on the low beams figure out which is low beam. Now go look at the HID harness, it will only use 2 pins, make sure they are in the right position with regards to your stock harness. |
The best way is to first get an electrical diagram for your car, then get a multimeter with continuity mode and draw and trace the module. It should be too hard, just take a bit of patience. |
All times are GMT -8. The time now is 01:08 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
SEO by vBSEO ©2011, Crawlability, Inc.
Revscene.net cannot be held accountable for the actions of its members nor does the opinions of the members represent that of Revscene.net