DIY k20 swap....need a lil help with KPRO + tuning my bad. berzerker i need a little help with my car. i did my own k20z3 swap in my EG...with a little help from my mechanic friend that works at dondocksteader volvo/subaru.....i got the engine running but its not running perfectly. if any of you have knowledge with KPRO / k20 please contact me!!!! |
I was going to offer to help you out... then I got annoyed with the way you typed so now I'm not. Berz out. |
berzzzzzz! haha i was listening rap all night!!! please help me out!!!! |
Word homie I totally feel ya. Sometimes when I hit that Rap Music tip hard I forget what color I am too. Sometimes I wanna straight cap a nigga after a couple hours of gangsta rap. Down to business... whats the car doing or not doing to make it not run right? Berz out. |
You need to elaborate on what's going on! Remember, we're not there listening to the car run... |
the engine runs, but on the TPS value in the kpro it says 109%, that means the TPS sensor is telling the ECU it is at full throttle....that means its running super rich? so i went to get a new TPS sensor, and it still doesnt work...car wont idle properly. its a k20z3 swap , im using 02 tb and engine harness and kpro |
Quote:
|
Sounds like it could be some simple wiring issue. We should be able to fix it and tune it for you. Give us a call at 604-931-8885 Thanks |
Press the gas pedal to the floor (ignition on, but car not running of course!) If it goes to zero, it's just wired backwards. Typically Pins 1 and 3 (or A and C) are +5v and ground, swap them. If it stays at 109%, unplug it. If it drops to zero pin 2 or pin B is wired wrong. If it stays at 109% regardless of throttle position and also with the connector unplugged, push it off a cliff. Or, to a shop. :D |
Quote:
|
k thanks guys for the advice...turned out that my map and tps sensor plugs were plugged the wrong way around...hahah fuck me. well before i swapped it around the car started and just didnt idle properly...after i swapped it back...now the engine cranks but wont start... im so confused...im gona check my sparkplugs n fuel later today |
mit you are a noob just bring it to david lol :P |
thanks guys! but car has started and running!!!!!!! vteccccc! |
All times are GMT -8. The time now is 02:54 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
SEO by vBSEO ©2011, Crawlability, Inc.
Revscene.net cannot be held accountable for the actions of its members nor does the opinions of the members represent that of Revscene.net