Wheel hub bore just a tiny bit too small
 

I have a set of wheels where the hub bore is 1mm too small. When I bought the wheels it was a gamble as some people say it fits, some say it doesn't.

Now if I want to just remove 1mm from the hub bore, what is the easiest way to do it short of sending it to a wheel shop?

send it to a wheel shop.

id say send it to a wheel shop and do it correctly

Easiest way? Hub centric rings but if it's that small (that's what she said :troll:) just send it to a wheel shop like Green's.

Nissan wheels on a Mazda/Hyundai/Kia/Mits?

You could run 5mm spacers or take a die grinder to them. You only have to remove 0.5mm.

3mm spacers may provide enough clearance if the bore is tapered on the wheel.

Bingo, Nissan wheels on a Hyundai. The front wheels fit, the back doesn't. Pisses me off.