My item list for b16a2 belt / seals / gaskets job - am I missing anything? Hi. I'm in the process of ordering all the parts for when I open up my engine to do the timing belt. It will be the first time that I've done it, myself. Here's what I've ordered so far: vtec solenoid gasket cam plug camshaft oil seals distributor o rings dowel pin & o ring Added: crank bold main seal Here's what else I'm going to order: timing belt water pump tensioner & spring head cover gasket set I replaced the alternator, AC, and power steering belts a few years ago and I've barely driven the car since then, so I'm not expecting to have to replace them during this job. I'm thinking of using a gatorback timing belt, because that's what was put in it last time, and it's been good for me, no noise. The car is a 99 EM1, and hasn't had any engine parts servicing since 2007, other than the replacing of the alternator, PS, AC belts and the motor mounts. Is there anything missing from my list that I should be replacing while going to the trouble of taking everything apart? Thanks. |
Crank pulley bolt and maybe a main seal. |
Quote:
|
Make sure you follow the correct procedure for installing that bolt. I believe it's xx torque, followed by xx degrees. Yes, I've used old bolts without issue, just gunning it on but I've also seen broken and over-torqued bolts. Best to just do it right. |
All times are GMT -8. The time now is 03:22 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
SEO by vBSEO ©2011, Crawlability, Inc.
Revscene.net cannot be held accountable for the actions of its members nor does the opinions of the members represent that of Revscene.net