Jon_39
08-26-2009, 12:46 PM
Ok, so after a barrage of messages and interest, here is the deal: I need about 2500 bucks for the upcoming school year, I will gladly sell this whole lot for 2500. If you come and get it, I am located in Nanaimo, and commute to Victoria bi-weekly, so transporting parts (as long as it isn't anything major) wont be an issue. I have had the car for 4 years, (2 of which it has been driving), and the clutch went in June of 2008, and has been sitting in my garage ever since.
Photos can be seen here (http://s302.photobucket.com/albums/nn85/dash4g/)
Here, by popular demand is a breakdown of parts and prices:
6 bolt 4g63t engine with large 16b turbo $$Any and all Offers Considered$$
purchased from Tiger Japanese (http://www.tigerjapanese.com) July 2006, from one of there generic postings like this (http://tinyurl.com/lsjx9u). Engine was inspected by Chrysler dealership, and all seals and belts as well as everything in between was replaced, and installed. Car was drivin ~10k on stock turbo, and 20k on new turbo (I will triple check these numbers when I get home).
[b]Intercooler Core (28x6.5x2.5) $100obo
This was purchased in June of 08' and it has not been installed, has been sitting ever since.
[b]2.5" Universal Intercooler Piping $125obo
This was purchased at the same time as the intercooler, and the listing is still up on ebay Here (http://tinyurl.com/n6r3pn)) I have cut a few pieces to fit, and I will post photos of that as well. There is NO BOV flange on this universal 2.5" piping, but I have a flange that can be used for welding or encorperating into someones setup in some way. The couplers that come with, are very cheap and after sitting for a year have actually started to rip apart, It is advised to purchase new couplers as well as clamps.
[b]EPROM ECU $225obo
As the title states, this is for a 1g AWD, with the caps being replaced when I bought it. I have the 28 pin socket to be soldered to the board Shown here (http://tinyurl.com/knozf7)) as well as another set of replacement caps for the lucky buyer.
[b]4-bolt rear end with rear driveshaft $100obo
This rear end has been a little sketchy when I have owned it, I have gone through 3 transmissions, all with blown VC's I have now deducted that it must be the rear end causing this, but if someone can deduct otherwise or get some use out of it, all the better.
[b]Walbro 255 $100obo
Brand new, out of the box, never installed, comes with paperwork, wires and filter.
[b]2gMAF $60obo (with 1g pigtail adapter)
Traded from John Hartman for my stock injectors, never installed by either of us, but the previous, previous owner vouched for its working order
[b]Data Logger cable w/USB to Serial cord $30obo
I have never used it with the usb to serial cable, but Shane Sawatzki can vouch for the logger working with his setup
[b]1gb Taillights and bumper $100obo
Purchased after my taillights got smashed, originally electric blue, spray-painted (quite nicely if i do say so myself ;) )to match my red body
[b]550cc Injectors (with new seals) $175obo
Purchased from RG racing, and from an earlier dsm post, they are these type:
1986-1987.5 turbo (195500-1370) TAN TOP peak/hold 550cc/min, low-impedance, square plug, side tab
[b]3" exhaust (No CAT) $250obo
Bought with the car, with muffler, Sounds absolutly amazing
[b]Nicely freshly painted black 1ga Hood with headlight covers $200obo
Was purchased with crappy rust and blotchy spots, and was repainted in my dads fiberglass shop with 'Hummer Black' and not glossy.
I will keep this post more up to date, and to get to me more directly please email me
Jrabeneck (at) gmail (dot) com ...
http://www.members.shaw.ca/hasek_39/000_0046.jpg
Photos can be seen here (http://s302.photobucket.com/albums/nn85/dash4g/)
Here, by popular demand is a breakdown of parts and prices:
6 bolt 4g63t engine with large 16b turbo $$Any and all Offers Considered$$
purchased from Tiger Japanese (http://www.tigerjapanese.com) July 2006, from one of there generic postings like this (http://tinyurl.com/lsjx9u). Engine was inspected by Chrysler dealership, and all seals and belts as well as everything in between was replaced, and installed. Car was drivin ~10k on stock turbo, and 20k on new turbo (I will triple check these numbers when I get home).
[b]Intercooler Core (28x6.5x2.5) $100obo
This was purchased in June of 08' and it has not been installed, has been sitting ever since.
[b]2.5" Universal Intercooler Piping $125obo
This was purchased at the same time as the intercooler, and the listing is still up on ebay Here (http://tinyurl.com/n6r3pn)) I have cut a few pieces to fit, and I will post photos of that as well. There is NO BOV flange on this universal 2.5" piping, but I have a flange that can be used for welding or encorperating into someones setup in some way. The couplers that come with, are very cheap and after sitting for a year have actually started to rip apart, It is advised to purchase new couplers as well as clamps.
[b]EPROM ECU $225obo
As the title states, this is for a 1g AWD, with the caps being replaced when I bought it. I have the 28 pin socket to be soldered to the board Shown here (http://tinyurl.com/knozf7)) as well as another set of replacement caps for the lucky buyer.
[b]4-bolt rear end with rear driveshaft $100obo
This rear end has been a little sketchy when I have owned it, I have gone through 3 transmissions, all with blown VC's I have now deducted that it must be the rear end causing this, but if someone can deduct otherwise or get some use out of it, all the better.
[b]Walbro 255 $100obo
Brand new, out of the box, never installed, comes with paperwork, wires and filter.
[b]2gMAF $60obo (with 1g pigtail adapter)
Traded from John Hartman for my stock injectors, never installed by either of us, but the previous, previous owner vouched for its working order
[b]Data Logger cable w/USB to Serial cord $30obo
I have never used it with the usb to serial cable, but Shane Sawatzki can vouch for the logger working with his setup
[b]1gb Taillights and bumper $100obo
Purchased after my taillights got smashed, originally electric blue, spray-painted (quite nicely if i do say so myself ;) )to match my red body
[b]550cc Injectors (with new seals) $175obo
Purchased from RG racing, and from an earlier dsm post, they are these type:
1986-1987.5 turbo (195500-1370) TAN TOP peak/hold 550cc/min, low-impedance, square plug, side tab
[b]3" exhaust (No CAT) $250obo
Bought with the car, with muffler, Sounds absolutly amazing
[b]Nicely freshly painted black 1ga Hood with headlight covers $200obo
Was purchased with crappy rust and blotchy spots, and was repainted in my dads fiberglass shop with 'Hummer Black' and not glossy.
I will keep this post more up to date, and to get to me more directly please email me
Jrabeneck (at) gmail (dot) com ...
http://www.members.shaw.ca/hasek_39/000_0046.jpg