Stock 4.25:1 trans w/ Kaaz LSD - $750
Stock Si tranny runs good , used as spare - $200
Endyn enduro prepared full race head with only 3 hours , valves/retainers/ race prep - $700
2 ea. stock cams (1 new in box o.e.) - $ 50 each
1 ea. custom Shadboldt cam - very lumpy idle? not sure which profile - $120
Skunk 2 manifold complete with AEM fuel rail - $250
Balanced and blueprinted injectors (used 1 season) included
AEM adjustable fuel pressure regulator - $50 no guage
AEM adjustable timing gear - $80
New in box o.e. Honda Master cyl - $100 7/8size
Wilwood front brake upgrade - everything except the adapter brackets
2 ea. used Wilwood Dynalite calipers - fresh seals
Wilwood discs (2)
2 ea Wilwood aluminum hats 4 x 100
Wilwood drilled / slotted discs (2) - have been used 2 sessions
Wilwood pads - 1 set new in box
- $700
New o.e. rear hubs for disc (2) with ARP extended studs - $80 each
Large diameter front sway bar 1 " - $80
Used radius rod spherical kit - $100
full race prepped bottom end with weisco pistons , eagle H beam rods, oil scraper.... Motor ran for a 6 hour enduro and started to blow by. We think the piston rings did not seat proper? $700 takes it away and I have new rings for it aswell
8 galon ALT fuel cell with bladder, foam, 2 filler caps, in tank pump included - $350
New Altrom distributor and complete MSD ignition including wires, SC ignition box , coil - dyno time only - $350
Chris Doodson
cdoodson@shaw.ca 
You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
The banners on the left side and below do not show for registered users!
