[Death2Theft]

I've seen adapters that allow you to go from a sata drive to a ata100 mobo, but is it true that you can't go from an ata100 hd to a sata mobo?

[Jeremy617]

idk how many more times i can mis-read this post. nevermind...

MY-Link IDE Ultra ATA 100/133 To SATA Converter Adapter: Amazon.co.uk: Electronics@@AMEPARAM@@http://ecx.images-amazon.com/images/I/31PJRW43ACL.@@AMEPARAM@@31PJRW43ACL

[Death2Theft]

I have a ide/ata drive that I want to use as my slave which only has sata ports and the master is also a sata drive.
The guy at ncix says if I got an pci card that is a ide controller it could work but not sure about the slave part as it would run it as a master.
idk how many more times i can mis-read this post. nevermind...

MY-Link IDE Ultra ATA 100/133 To SATA Converter Adapter: Amazon.co.uk: Electronics (http://www.amazon.co.uk/MY-Link-Converter-Adapter-Suitable-Driver/dp/B000LU28U4)

[Jeremy617]

the master/slave relationship that existed with IDE is not applicable for SATA stuff.

if i read that correctly, you have one sata and one IDE drive? Then i also would suggest some sort of an add-in card with an IDE port, pci or pci-e. Adapters like the one i linked would probably be flaky.

edit: thats if you really MUST use that ide drive. best solution is just to spend $50 on a new sata drive to replace it... if its IDE i'm assuming its very old, and its definitely going to be slow.

[!MiKrofT]

+1. for all that trouble of getting the adapter just buy a cheap SATA drive.

[lilaznviper]

+1 on getting a new drive. you can get a 2tb for 70 bucks