[Boostaholic]

I bought these side skirts off ebay and they are like 1 inch too short. They are are also kinda twisted a bit. Anyone know how I can install these? I did some googling and people say fiberglass side skirts usually needs to be cut then lengthened with more fiberglass. Anyone done it before?

[Grim]

yea its not hard, but not fun to do
go to can tire, buy fiberglass cloth/resin.
cut the side skirt in the middle and get a flat surface to place the side skirts.
use a piece of 1/8" or 1/4" wood and screw/hot glue the inside bottom of the skirt to make sure its level and even.
start adding the resin / fiber cloth in small coating and try to follow the lines of the skirt.
keep going until the fiberglass is 1/16" thick then add bondo on surface and sand till it matches your side skirt details.

remove the piece of wood if possible

[bcrdukes]

Throw them in the trash.

[325isMSPORT]

drill and zip ties

[Nlkko]

Trash them and dont buy body kits off ebay next time.
Posted via RS Mobile

[AW607]

ebay kits :fuckthatshit:

But if you are going to do some fiberglass work, always always gotta wear gloves.. I've had some bad experiences going gloveless with fiberglass :okay:

[westopher]

I came in to write install them into the garbage, but dukes beat me to it. Let it be a cheap lesson not to buy shitty quality stuff, before you waste more money for it to be an expensive lesson.

[firebird79_00]

I wouldn't even bother, throw them in the dumpster and wash your hands
Posted via RS Mobile

[matteblk]

if there slightly warped you can just bake them on a flat surface... it does work, but shortness?.... ahhh JUNK BIN

[kwy]

Dealt with ebay kits before..fitment is almost always awful. should stay away from that stuff. hell, even some brand name stuff needs modification to fit properly. hindsight 20/20.