[emtee_23]

hey guys,

was hoping to find a place who can do 2 bends of a 3inch exhaust pipe (67.5 & 90 degree bend)

any info of where i can go would be greatly appreciated.

:)

[Gucci Mane]

muffler tech performance exhaust (http://mufflertech.ca/)

took 5 seconds on google....

[emtee_23]

muffler tech performance exhaust (http://mufflertech.ca/)

took 5 seconds on google....

well i figured that out earlier this week. one guy said they can do it, one other guy i spoke to today said they can't do anything more than 45 degrees.. don't know if he was bullshitting me or not. just wanted to know if i had other options other than muffler tech in coquitlam.

[fliptuner]

What's it for? You can just buy pre-bent pipes.

[emtee_23]

What's it for? You can just buy pre-bent pipes.

I guess I could but I'd prefer the exact angle I need. It's for a diy snorkel. Priced it out and it's cheaper than buying the plastic snorkel that routes underneath th3 air box

[sdubfid]

Much further ahead buying 2 90s and cutting tangent to get your 67.5. If you are looking for stainless I might even have a scrap that you could cut 67.5 out of.

[emtee_23]

Much further ahead buying 2 90s and cutting tangent to get your 67.5. If you are looking for stainless I might even have a scrap that you could cut 67.5 out of.

Sweet ok I'll pm you if I decide that route!