|
FS: 90-degree bent valve stems for your deep dish custom wheels
Length on the neck is 2.80" and the hole requirement is the same as the hole in which one could pull a standard rubber valve stem through.
Asking $20 obo. Looks like these: http://www.blackjacktirerepair.com/i...Vs-PVR-153.jpg Never used only opened the packaging to test fitment. Not going to work with some JDM wheels such as SSR and Watanabe.... But it might just work out for your application. |
SOLD
|
| All times are GMT -8. The time now is 07:15 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
Revscene.net cannot be held accountable for the actions of its members nor does the opinions of the members represent that of Revscene.net