|
The question is rather vague.. what do you want to do? just a reburishment? bore out?
Basic things you should do:
0. Figure out your goals, get the manual for torque specs etc.
1. Measure what you have, leak down etc.
2. Teardown and evaluate the engine.. ie check for wear in block and components, hot tank and leak check... blue print the engine.
3. Purchase parts and gasket sets.
4. Machine if needed.
5. Reassemble, check for leaks etc, engine stand run etc.
Engine assembly is not too hard, it takes patience. Everyone has to start somewhere, so start at where it is simple and relatively low cost.
Documentation I think is very important.. so get a good lab book.. I suggest say a UBC Chemistry lab book.
| 
You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
The banners on the left side and below do not show for registered users!
