| 1985 GMC S-15 Pickup No Start No fuel
Hey guys. I have a 1985 GMC S-15 pu with a 2.5L engine. I have got a no start problem. This injector will not spray unless you ground the lt. blue wire at the TBI or the ECM. Of course it sprays constantly and will run as long as the circuit is completed or until all the fuel in the manifold is burned. I have checked the trouble codes several times. The only one I can get is a Code 12 (no codes showing). I have checked the wiring between TBI harness, MAP sensor, coolant sending unit and the ECM. The continuity was fine in all the wires and none were loose in the connectors. So I replaced the ECM. This did not fix anything. I am thinking about pulling the engine harness and bench testing. The TPS and the MAP sensors appear to be working properly. No fault codes and the voltages were in specs. I also ohmed all three ground wires at the ECM which turned out ok also. If anyone could enlighten me, I would appreciate it. Been spinning wheels too long. Thanks
| 
You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
The banners on the left side and below do not show for registered users!
