parts are for an f22. All Brand New
f22 turbo bottom end build
Bisimoto 86mm custom forged pistons and rods, built by arias pistons for bisimoto and bisimoto long ratio rods (these took four months to build & get!) with a bisimoto 86mm head gasket and king main, rod, and thrust bearings, arp Head and main studs, arias piston rings and 20-30psi upgraded wrist pins - compression ratio is 9.1 more specs at your request. I may even be able to get you a spare f22 short block. This set up is insane, good for well over 400-500whp,
$1400
f22 copper 2mm turbo head gasket. this head gasket will lower compression 1 whole point,
$70obo
f22 toga HV oil pump,
$190
Precision 880cc injectors
$300obo
f22a Obx Top Mount Manifold & downpipe
$200
Kteller 3inch Exhaust Kit
$200
Full f22 Turbo kit (everything except a block fitting for oil feed. comes with -3 oil feed line and an fittings, -10 and oil drain. hks ssqv bov, 60trim cxturbo, kazien fmic kit with custom welded charge Pipes , 440cc injectors, Chipped p06(vtec ready) ecu w/440cc dyno tuned chip. top mount manifold and downpipe, drift motion 38mm wastegate. ecttt. this kit is basically plug and play
1400?? obo
rods
Pistons
Injectors
OilPump
Copper headgasket
Topmount
Kteller kit
You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
The banners on the left side and below do not show for registered users!
