Quote:
Originally Posted by knockoff  3d Ink
owner is a car guy too, cool dude.
just out of curiosity... why not do it yourself? Not too difficult. |
Have you done it? Cause it actually is quite difficult to get a good pattern, then there is the prep work, and I would have to clear the pieces etc.
I am all for DIY, but I have no intentions of buying a dipping starter set, figuring out how to use it, practising until I can do it well enough, going through all the work to seal the surfaces after dipping. Then in the end being left with something that isn't up to my standards.
I just want a few pieces under my engine bay done, and I want them done right. So I am willing to pay someone to have it done.
I will check out 3D ink, as well as the location that Berz sent me. Im sure one of them can do the simple pieces I want done.
Thanks guys. You can always count on Revscene
You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
The banners on the left side and below do not show for registered users!
