Quick question re: Offset of wheels
 

Might be a noob question, but just wanted to double check with people that are in the know...

If my car uses stock 17x7 +55 offset wheels, is it safe to replace them with wheels that have a lower offset? i.e. +35, +40, +45

I know this probably should go in the wheel/tire tech forum, but i'm looking for a quick response so I can decide whether or not to buy some wheels asap.

Thanks!

yes, but only to a certain extent


for example

my car is 17x7.5 45 offset stock

and im running 18x8.5 31 offset



rim size x x number (the width of the rim) offset pushes the rims further out


if u are going for extreme setup, fenders may required to be rolled. Depending on what car, what do you drive?

2010 wrx 265

so stock is +55

i'm thinking about getting some 17x7 +40 wheels...

is that ok?

yup totally fine, but depending on how wide on the rims as well

checking fitment for you right now


pmed u

google

offset calculator
i remember there's this one from a miata forum which was very useful

Subaru?
Go wide or go home

go home

:)

Use this Offset Calculator:
http://marksink.com/tire_wheel_offset/offset.html

From 17x7+55 to 17x7+40:Then you can check yourself whether there are any clearance issues.

+1

+2

plenty of older model subaru owners ran 18x10s with low offsets.
hellaflush.com

This is key... depending on the car of course.. but if you run too high an offset, and your car is next-to-slammed... you may run into problem if you carry heavy loads or have fat-assed friends.

My stockers were 6" wide rims with a 40mm offset, I ran 8" wide rims with a 35mm offset, then the wheels stuck out too far and rubbed on the rear quarter panel if I had lots of stuff in the trunk or a full load of people. :(

If there's a template available... you can print out the rim clearance and hold it up to your rotor/drum and see what your clearance will be like for the calipers, etc..

measure the horizontal spacing between ur tire and the fender.

then you can guestimate how wide you can go with a stock wheel set up.

cool thanks for all the responses everyone

yea, the car isn't lowered, and probably won't be... so as long as i don't deviate too much i'll assume it's ok.

best place to ask would be on your car specific forum and visit their tire/wheel section, they usually have a post dedicated to wheel fitments on the specific model